Link Search Menu Expand Document

Fill Color

The Fill Color of a selected figure can be changed to meet a desired preference. It can be altered for a selected figure(s) or in instances where no figures have been selected. If a figure has not been selected, the color change applies to any figure added after the change. This attribute can be altered in one of the following ways:

  1. Press on the Fill Button located in the Drawing Toolbar.

  2. Press on the Info Button in the Top Toolbar.

    Then tap on the Fill option to open the popover window shown below.

To alter the Fill Color:

  1. Tap on the On/Off toggle slider in the upper right hand corner of the Fill Window to turn on the Fill option. The slider will appear with a green background when this option is enabled.

  2. Next, press on the desired color selection method (Wheel, List, or Favorites). In this example, the wheel is chosen.

  3. Tap on a color range within the outside of the wheel view.

  4. Choose the desired lightness or darkness of the selected color in the center (saturation) square.

  5. Perform a Touch/Drag gesture combination or Press on additional options such as the opacity slider within the Fill Window to make further attribute changes.

  6. Tap anywhere within the Drawing Editor to close the window. The following screenshots show a figure that has been changed to a light blue fill.

Note: A color change will be seen instantaneously when a stroke figure is selected. If no figures have been selected, the color change will apply to all subsequently created stroke figures.


Table of contents


Copyright © 2010-2020 Elevenworks LLC. All rights reserved.